Tools required to adjust the Nissan 350z headlights.
12” Phillips screwdriver with a #2 tip.
Adjustment Guide
Step 1. Drive the vehicle to a flat surface about 8 inches from the wall.
Step 2. Place the screwdriver into the X marked in the picture.
Step 3. Turn the screwdriver to adjust the headlight beam. Turn the screwdriver clockwise to move the headlight beam up and counter clockwise to move the headlight beam down. After about five revolutions you will see some changes in the headlight beam.
Step 4. After adjusting the headlight beam you want to measure the wall. The headlight beam should focus about 26 inches from the ground. That’s it you’re finished.
This example will work for almost all types of after market headlights. Remember that if your vehicle is lowered, the measurement should be lowered according to the amount of the drop.
Warning Disclaimer: The following instructions are given for informative purposes only. Try at your own risk. Turbo Metal is not responsible for damages because of this process.
Comments
There are no comments for this post.
Write a Comment
You must be logged in to post a comment.